Custom & Speed Parts - Online-Shop for VW Beetle, Bus, Thing, Type-3, Karmann Ghia and Porsche 356 - Custom & Speed Parts CSP

Engine Case Hardware Kit Type-1

Engine Case Hardware Kit

This hardware kit should be purchased together with every new Type-1 engine case. It is necessary to complete the engine case and to make it fit the different configurations, depending on which air-cooled car the motor is build for.

The kit contains not only oil pressure valves and other needed parts, but also the block off plate for the Type-3 oil pick-up tube plus the different studs and adapters for various oil coolers. The CSP Prodcuts engine case hardware kit contains all parts listed in the orginal spare parts catalogue.

To meet today's requirements we added longer studs for 30 mm oil pumps and studs with a length of 95 mm. They must be used, when the engine will be mated to a later 091 Bus gearbox, as used in Type-2's from '76 onwards.

For this kit we only use parts from our own production or products from German suppliers to guarantee a constant quality standard.

Parts contained according to the spare parts catalogue:

  • 1 sleeve for oil cooler mounting
  • 1 gasket for Type-3 pick-up tube
  • 1 CSP Products stainles steel block off plate for Type-3 pick-up tube
  • 2 CSP Products pistons for oil pressure and oil pressure relief valve
  • 1 spring for oil pressure relief valve
  • 1 spring for oil pressure valve
  • 2 CSP Products plug screws for oil pressure and oil pressure relief valve for 8 mm hexagon wrench
  • 2 O-rings for plug screws for oil pressure and oil pressure relief valve
  • 2 hexnuts M8
  • 2 spring washers M8
  • 4 studs for oil pump 21/26 mm
  • 2 studs for fuel pump
  • 1 stud for oil cooler M8
  • 1 stud for oil cooler M8/M6
  • 2 studs for engine case (not w/ Bus 091 gearbox)

Additional pieces in this CSP Products hardware kit:
  • 4 studs for oil pump 30 mm
  • 2 studs engine case long (for Bus 091 gearbox)

p65warning Warning: Using this product can expose you to chemicals which is known to the state of California to cause cancer and cause birth defects and/or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Engine Case Type-1
These Type 1 engine cases are made of AS41-material
show details
Nut Engine Case
Fits type-1 engine cases
show details
Washer Engine Case
Fits type-1 engine cases
show details
Case Savers
The case safer sleeves are available with M8-thread on the inside and M12x1
show details
Sealing Compound Curil K2
Curil K2 is a Non-Hardening Sealing Compound which can be applied with an excellent sealing effect on
show details
High Performance Sealer Dirko HT
A permanently elastic, high-temperature resistant, high-performance seal in a tube
show details
CSP Cylinder Studs
Type-1 1300cc -
show details
Starter Engine Bolt
Beetle/Karmann Ghia, Thing (181), Type-3, Bus -'75
show details
Mounting Kit Engine to Gearbox
Beetle/Karmann Ghia, Thing (181), Type-3, Bus -'75
show details